If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help display mode stuck
The display mode is stuck on 640x480 and colour won't
change from 16 colours mode. |
#2
|
|||
|
|||
Help display mode stuck
Sounds like your Display Adapter driver is no longer being properly
recognised, is incorrectly set-up, or is corrupted. Boot into Safe Mode and in Device Manager, 'Remove' any/all Display Adapters and Monitors and then re-boot. WinMe *should* re-detect (Plug&Play) your video card and monitor and then should install the 'correct' drivers. If it still doesn't help, you'll need to install the latest WinMe driver for your Video Card (Adapter) which you should be available to download from the card manufacturers web site. HTH and good luck Mart wrote in message ... The display mode is stuck on 640x480 and colour won't change from 16 colours mode. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Display 'grainy' like safe mode | Suz | Monitors & Displays | 6 | June 30th 04 07:18 PM |
stuck on safe mode | General | 2 | June 27th 04 05:31 PM | |
stuck in safe mode | Peter | Monitors & Displays | 3 | June 15th 04 10:07 PM |
setting display via dos mode | tunde martins | General | 1 | June 7th 04 12:00 PM |
computer stuck in safe mode | [email protected] | Setup & Installation | 2 | June 4th 04 10:12 PM |