|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 15th 04, 06:44 PM
|
|||
|
|||
error -1
partitioned my hard drive, booted to start up disk, ran
scan disk, but when I chose "setup", I get this error message: Failed to convert destination filename with error -1. Run Setup again... Does anyone know what is wrong? Thank yuo very much. Mimi 
|
|
#2
July 16th 04, 05:40 PM
|
|||
|
|||
|
error -1
try to format from the statup disk, then try install from cd. If that still does not work you may have a bad cd.
"Mimi" wrote: partitioned my hard drive, booted to start up disk, ran scan disk, but when I chose "setup", I get this error message: Failed to convert destination filename with error -1. Run Setup again... Does anyone know what is wrong? Thank yuo very much. Mimi
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
