If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Display Is Shaky!
Hello Newsgroup,
I have just reformatted my hard drive and installed Win98. During start up and when the operating system finishes loading, the display on the monitor(ViewSonic) shakes back and forth. When any program is opened the problem is gone. How do I fix the shaking problem during start-up? Thanks, Chantel |
#2
|
|||
|
|||
Display Is Shaky!
Hi Chantel,
This usually indicates that there is an incorrect video driver installed. Here's some information on replacing the video driver. Tip: Go to Start - Run and type Msconfig and press enter. On the General Tab click advanced, and make sure "VGA 640x480x16 is NOT checked before continuing. To correct this you will first have to identify the video card installed. That may include checking documentation, contacting the system manufacturer, or opening the box and looking for identifying marks on a video card or video chip on the mother board. Some systems will display the Video Adapter information on the top of the screen when the system first boots up. Some manufacturers displays a logo screen that may cover this information. It may be able to be removed temporarily by pressing the ESC key when the logo first appears. Once the Video card has been identified, go to the manufactures web site, download and install the latest video driver and install it as per there instructions. Or the system may have shipped with a video card driver it can also be used. -- Regards, Bert Kinney [MS-MVP DTS] http://dts-l.org/ How to Configure Outlook Express for Internet News: http://support.microsoft.com/default.aspx?kbid=171164 "Chantel" wrote in message Hello Newsgroup, I have just reformatted my hard drive and installed Win98. During start up and when the operating system finishes loading, the display on the monitor(ViewSonic) shakes back and forth. When any program is opened the problem is gone. How do I fix the shaking problem during start-up? Thanks, Chantel |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
hover buttons won't display | Ken Bouchard | Internet | 9 | July 7th 04 01:12 PM |
cannot display page | purensweetie | General | 1 | June 28th 04 02:51 AM |
Display and Mouse problems on start up | Lisa | General | 23 | June 21st 04 09:06 PM |
setting display via dos mode | tunde martins | General | 1 | June 7th 04 12:00 PM |
Display too large for monitor screen | David | Monitors & Displays | 5 | June 4th 04 02:13 PM |