|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 19th 04, 04:07 AM
|
|||
|
|||
Missing Colors
In order to follow the rules of the site, I am submitting
my question again, without my email address. Some of my colors are missing from my windows 98se monitor. I tried Display Properties, but the resolution setting are correct, and I can't figure out what to do now. I only have yellow, dull green and black, no blues or reds. How can I fix this? Any help would be much appreciated! Thanks, Bea 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ZoneAlarm missing Firewall Zones tab for subnet. New NAT router won't show Entire Network. | Networking | 5 | July 5th 04 09:48 AM | |
| ZoneAlarm missing Firewall Zones tab for subnet. New NAT router won't show Entire Network. | Networking | 5 | July 5th 04 09:48 AM | |
| Help! Wheres my colors | Monitors & Displays | 2 | June 9th 04 09:13 AM | |
| Monitor Resolution set too high, use safe mode to fix,now have only 16 colors | John | Setup & Installation | 2 | June 4th 04 05:25 AM |
| missing dll files | peterb | General | 1 | May 21st 04 11:12 AM |
Linear Mode
