If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
1 - Is USB enabled in the BIOS?
2 - What chipset is on the motherboard? Everest should tell you this. Joe "Keith" wrote in message ... I have 98SE installed on this computer. I had my Palm installed and working on the other computer that I just transferred everything from. I don't have the paperwork for the camera anymore, but I did have it installed and working on a computer other than these two that I have mentioned and that computer also had 98SE. I used the installation disk for both items and installed evrything before I rebooted and connected the devices to the USB ports, but no new hardware wizard appeared. What should I do at this point? Thanks. Keith. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
display properties | fgoodytally | Monitors & Displays | 1 | August 29th 04 04:05 AM |
display properties | mowmow | Monitors & Displays | 1 | August 17th 04 02:49 PM |
I want to disable the Display Properties | Johnny So-Green | Monitors & Displays | 1 | August 12th 04 08:35 PM |
display reverted to vga and 16 colors for patriot computer | rosenmarsh | Monitors & Displays | 3 | July 4th 04 11:36 PM |
Display Properties | Simon | Monitors & Displays | 0 | June 18th 04 12:56 PM |