If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
AMI BIOS
I have a Tiny 800mhx AMD on a MS-6340 main board. I
installed an orignal roxio photo-suite 5 and when i restarted after the install my computer wouldn't even launch the bios page. This is what has happened on various different restarts. I reset the bios and changed the battery. BIOS page loaded and said CMOS Settings Wrong and CMOS/GPNV Checksum BAD. press f1 to set up or F2 to load defaults. Sometimes the keyboard doesn't respond here, and some time it does but i just get a black screen with blinking _ in the top left. Sometime when i restart i just get CMOS Settings Wrong and the same as above happens. Now I cant even get that, i just get a blinking _ in the top left corner. I have changed the memory and unplugged all the hardware and reseated everything but it dont make any difference. Some times I get a 2 beep error message other times i get a 2beep, 1 beep code. Before i installed this Roxio Photo-Suite it was working fine. THANKS |
#2
|
|||
|
|||
AMI BIOS
It maybe difficult but try to boot from the ME Safety Boot floppy you should
have on hand. If successful run SCANREG/ RESTORE from the A:\ prompt and select a date/time before the Roxio software was installed. Hopefully this will allow Windows to start notmally. "Doughy" wrote in message ... I have a Tiny 800mhx AMD on a MS-6340 main board. I installed an orignal roxio photo-suite 5 and when i restarted after the install my computer wouldn't even launch the bios page. This is what has happened on various different restarts. I reset the bios and changed the battery. BIOS page loaded and said CMOS Settings Wrong and CMOS/GPNV Checksum BAD. press f1 to set up or F2 to load defaults. Sometimes the keyboard doesn't respond here, and some time it does but i just get a black screen with blinking _ in the top left. Sometime when i restart i just get CMOS Settings Wrong and the same as above happens. Now I cant even get that, i just get a blinking _ in the top left corner. I have changed the memory and unplugged all the hardware and reseated everything but it dont make any difference. Some times I get a 2 beep error message other times i get a 2beep, 1 beep code. Before i installed this Roxio Photo-Suite it was working fine. THANKS |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bios disabled? | Anthonage | Improving Performance | 15 | July 27th 04 07:42 PM |
creating a password | jean | General | 1 | July 15th 04 03:50 AM |
Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |
Large Hard Drive & BIOS upgrade problems | Lago Jardin | General | 17 | June 11th 04 07:27 PM |
Flashed BIOS - IDE controller problems | Storm | Disk Drives | 1 | May 9th 04 03:44 AM |