Ben B
June 20th 04, 04:14 AM
Hello Rick and Mart,
A long thread on June 1st. and events subsequent prompt
this post. I hope this clarifies for you both something
seemingly without resolution.
Yesterday I had success at a partition, format and install
of WinMe. I was lucky - for two hours before I began it my
EBD failed. A week prior I found that the computer's
connecting ribbon to my CDROM drives was faulty. I had
been unable to burn CDs. The ribbon I changed. The burn
fest began.
The installation was carried out using a newly created EBD
on the Add/Remove program. The drive used for the disc
insertion was my H CDROM. I accessed it, by using, in
DOS, 'With CDROM support', and at the A:\> I:.
So there it is. Too many odds against each of us. My
thanks for help past and my best wishes to you each, Rick
and Mart.
Ben.
A long thread on June 1st. and events subsequent prompt
this post. I hope this clarifies for you both something
seemingly without resolution.
Yesterday I had success at a partition, format and install
of WinMe. I was lucky - for two hours before I began it my
EBD failed. A week prior I found that the computer's
connecting ribbon to my CDROM drives was faulty. I had
been unable to burn CDs. The ribbon I changed. The burn
fest began.
The installation was carried out using a newly created EBD
on the Add/Remove program. The drive used for the disc
insertion was my H CDROM. I accessed it, by using, in
DOS, 'With CDROM support', and at the A:\> I:.
So there it is. Too many odds against each of us. My
thanks for help past and my best wishes to you each, Rick
and Mart.
Ben.