LUTRA
December 6th 04, 04:57 PM
During a repair process recently I disabled Scandisk following the procedure
outlined in KB-152404. I decided now to ENABLE it again and have done so. But
I noticed in the article that it mentions the Msdos.sys file would have been
changed to add the value of AutoScan=0 during the disabling process. Would
this be changed back when I enabled it again or do I have to do this
manually? Can someone direct me?
outlined in KB-152404. I decided now to ENABLE it again and have done so. But
I noticed in the article that it mentions the Msdos.sys file would have been
changed to add the value of AutoScan=0 during the disabling process. Would
this be changed back when I enabled it again or do I have to do this
manually? Can someone direct me?