IDE drivers

[Mike Busch]

I was trying to use the CD on a IBM 300PL with 128 MB Ram,
a 663 Mhz processor, and 10Gig Hard drive. It has windows
98, and I can not find the CD ROM, the BIOS looks OK but
when I go to Device manager I receive an error when I
check the status of both the Primary and secondary IDE
Controllers. A Yello explanation mark drew my attention to
this. The status states Primary IDE Controller dual fifo
"The device is not present, not working properly or does
not have all the drivers installed (code 10). This is the
same message I receive from the Secondary IDE controller.
Any help would be appreciated. Thanks in Advance.

[Ron Badour]

Boot to safe mode, delete both controllers, reboot and let Windows redetect
them.

--
Regards

Ron Badour, MS MVP for W98
Tips: http://home.satx.rr.com/badour
Knowledge Base Info:
http://support.microsoft.com/default.aspx?pr=kbinfo

"Mike Busch" > wrote in message
...
> I was trying to use the CD on a IBM 300PL with 128 MB Ram,
> a 663 Mhz processor, and 10Gig Hard drive. It has windows
> 98, and I can not find the CD ROM, the BIOS looks OK but
> when I go to Device manager I receive an error when I
> check the status of both the Primary and secondary IDE
> Controllers. A Yello explanation mark drew my attention to
> this. The status states Primary IDE Controller dual fifo
> "The device is not present, not working properly or does
> not have all the drivers installed (code 10). This is the
> same message I receive from the Secondary IDE controller.
> Any help would be appreciated. Thanks in Advance.