A: Device Is Not Ready

[Angela]

Whenever I try to access a floppy, I get Device Is Not
Ready.

1. Have replaced Floppy Drive
2. Have replaced Floppy Cable (Light does NOT stay on)
3. Drive is correct in BIOS
4. Can boot to Command Prompt and Can run dir and see
contents.
5. Have removed both floppy disk controller and disk,
still having issue after reboot.

Please Advise.

Thank you,
Angela

[Bert Kinney]

Hi Angela,

Here are some steps to take for troubleshooting floppy drive problems.
1. Check to see if drive is unchecked in Tweakui.
2. Check system to make sure it is free of a Virus or Spyware.
3. If installed, turn off Dr. Solomon anti virus program.
4. Restart the computer. Hold CTRL while the system is booting.
Pick Command prompt only and test the drive.
5. Restart your computer by holding down the ctrl key and use the
"boot menu" to enter a safe mode windows session. Then in Device
Manager, locate and delete floppy drives *and* the floppy disk controllers.
Restart to see if Win98 re-detects properly.
6. If using a tape backup unit, remove/disconnect to see if
floppy function returns; if so, hunt for new tape drivers.
7. If using Norton Utilities, upgrade to 3.07 (or later, if
available) and/or disable Disk Doctor against the floppy drive.
8. Start | Run | msconfig | Selective startup | Un-select all
entries | restart | turn on one startup item, in turn, with restarts
between | when floppy ceases to function, you know the problem
is in the last file activated, so search and edit as needed.
9. CMOS settings are incorrect: write down all settings, then
re-set to defaults, restart to CMOS, re-enter the written down settings.
10. CMOS settings are incorrect: if "Swap Floppies" is enabled,
disable it.
11. Ribbon cables are 180 degrees out, or otherwise
mis-aligned/tilted: to correct, properly position connectors and
tracer color wire always to pin number 1 at both ends.

--
Regards,
Bert Kinney [MS-MVP DTS]
http://dts-l.org/
How to Configure Outlook Express for Internet News:
http://support.microsoft.com/default.aspx?kbid=171164

"Angela" wrote
> Whenever I try to access a floppy, I get Device Is Not
> Ready.
>
> 1. Have replaced Floppy Drive
> 2. Have replaced Floppy Cable (Light does NOT stay on)
> 3. Drive is correct in BIOS
> 4. Can boot to Command Prompt and Can run dir and see
> contents.
> 5. Have removed both floppy disk controller and disk,
> still having issue after reboot.
>
> Please Advise.
>
> Thank you,
> Angela