jettt
September 26th 04, 12:30 AM
My printer, HP 7210 all-in-one, is connected via usb.
Following reboot, the device reports to be 'ready'. When
printing a test page, the message, "Data error (cyclic
redundancy check) USB001" appears and the device then
reports to be disconnected. I've changed the usb cable out
and tested the printer on my laptop (it works fine).
Any suggestions?
Thanks.
Following reboot, the device reports to be 'ready'. When
printing a test page, the message, "Data error (cyclic
redundancy check) USB001" appears and the device then
reports to be disconnected. I've changed the usb cable out
and tested the printer on my laptop (it works fine).
Any suggestions?
Thanks.